Affects on the Waxing Stone Maintance

It is vry often that stone material installation personnel complaint that it is not obvious of the stone maintance, which cannot protect the stone materials. Some people even say that the stone go rot just because the stone material is processed by protective agent, for example, the yellow spot on the surface or oil spots. What is the protective agent on earth? How to deal with it to play its role as the protection. On which stage to deal with the stone with protective agent can reach the best effects?

The problem stone business faces is the maintance trouble mostly take place atfer the installation, which often follows the business problems. The installation personnel and the ownerof constructionindustry is tend to meet this problem. Therefore, when seek the reason of the stone problem, the key point is concentrated on if the installation personnel use the disqualified stone material, if the installation personnel reduce the stone material, if the way the installation personnel use is right or not. But for the stone supplier, namely ,stone factory, should not be considered. Of course,the most direct reason to the rot stone is way used to deal with th estone and the protective agent.while many rob stone take place originally during the procedure used to process the slabs. That is to say the procedure to process the slab can indirect cause the bar for stone maintance. it is much more difficult han you can imagin to settle this problem and its consiquential problems. The problem rate as such is acturally very high, but always are neglected by people. Therefor, for one of the easiest procedures---waxing, we analyze its advantages and dis advantages. And we can advise the stone factory to make the procedure into standard procedures.or we can suggest to build up the special factory for the stone maintance in order to perfect the stone maintance project.

Stone material is the natural construction material. There are many microgroove annd lines and disgloss caused when the stone is formed. The factory often adopt many ways to raise the surface gloss, and to reduce the microgroove annd lines. The mostly uesd way of the stone factory is to wax on the tumbled surface. Not only to raise the gloss, but also to reduce the microgroove annd lines. This way, to the stone factory ,is very convinient and economical. But for the installation personnels and the consumers, this is a big problem. The reason is that wax is one kind of surface protective material, when the wax cover the surface of the stone the wax on the surface block the protective material to go deep into the inner stone, which lead to that the protective material stay on the stone surface so the protective maintance fails and increase the consiquential problems. Many waxing stones are exposed in the air or the sun, so the yellow sopts grow on the surface. This is the main reason the stone becomes yellow.

If want to protect the waxing stone ,some people adopt the wax removel to clean. But the effect is not as good as expected.the following is the main reason:

1. bad effect of wax removel

2. the remains of wax removel cause the indirect pathological changesAs the matter of fact, from the poinview of chemistry, the failure rates are higher than the success rates. It is the same like that doctor save the poisoned person. We should analyze the chemical elements in order to give the right prescription. At the same time, the poison remains should not be remained.acturally, this is very difficult, hardly reality.

In sum,it is easy to find that the stone factory should consider the problem that the protective agent as the stone material protection perfect the stone material in order to avoid the sequential difficulties. To do these, the problem rate can be lower, and eliminate the consumers’ misgivings about the stone materials.